Driver for serial PCIs
  | 
You must be root to start this driver.
 | 
 
 
devc-serpci [vid=vid,did=did[,pci=pci]] [options] &
Neutrino
x86
- -b number
    
 
- The initial baud rate (default 57600).
    
 
- -C size
    
 
- The size of the canonical buffer in bytes (default 256).
    
 
- -c clock[/divisor]
    
 
- Define a custom clock rate, in hertz, and divisor for the serial port. The default (-c 1843200/16) is suitable for compatible PC serial ports.
	
 
- did=did
	
 
- The PCI device ID, in hexadecimal (0xXXXX).
    
 
- -E
    
 
- Set options to “raw” (default).
    
 
- -e
    
 
- Start in edited mode (default raw). Software flow control is enabled by default.
    
 
- -F
    
 
- Disable hardware flow control (default to hardware flow control enabled). Hardware flow control is not supported in edited mode.
    
 
- -f
    
 
- Enable hardware flow control (default). Hardware flow control is not supported in edited mode.
    
 
- -I number
    
 
- The size of the raw input buffer in bytes (default 2048).
    
 
- -O number
    
 
- (“Oh”) The size of the interrupt output buffer in bytes (default 2048).
	
 
- pci=pci
	
 
- The PCI index, in decimal (XX).
 
- -S|s
 
- Disable / enable software flow control. The default depends on the
  mode: in raw mode (-E, the default), it's disabled;
  in edited mode (-e), it's enabled.
  
  The order in which you specify the -E or -e, and
  -S or -s options matters:
  
| Options
       | 
Mode
       | 
Software flow control
   | 
| -e
       | 
Edited
       | 
Enabled
   | 
| -S -e
       | 
Edited
       | 
Enabled
   | 
| -e -S
       | 
Edited
       | 
Disabled
   | 
| -E
       | 
Raw
       | 
Disabled
   | 
| -s -E
       | 
Raw
       | 
Disabled
   | 
| -E -s
       | 
Raw
       | 
Enabled
   | 
 
- -t number
 
- Enable the receive FIFO and set its threshold to 1, 4, 8, or 14 characters.
The default is 0 (trigger disabled).
 
- -u number
 
-         Append number to the device name prefix
        (/dev/ser).  The default is 1; additional
        devices are given increasing numbers.
	
 
- -v
	
 
- Increase verbosity.
	
 
- vid=vid
	
 
- The PCI vendor ID, in hexadecimal (0xXXXX).
 
The devc-serpci manager is a small serial device manager for QNX Neutrino. This driver supports 16Cxxx compatible Serial PCI cards.
  | 
The boards must use PCI I/O space for the registers, and the ports must be
contiguous in memory. | 
 
devc-serusb